GimmeProps · prop and costume makers ✦

Workshop basics

EVA foam for prop making: cut sharp, heat gently, seal before paint.

Most cosplay armour, from a Spartan Halo costume to a fantasy helmet, starts as sheets of EVA foam for prop making. It is cheap, light and forgiving once you know four techniques.

GimmeProps was a social network for prop and costume makers; this is the workshop sheet we would pin first.

Choosing EVA foam thickness

Match the foam to the job.

The same sheets cover Halloween prop making, from shields to masks, and full armour builds.

Common thicknesses
ThicknessTypical use
2 mmtrim, raised details, layering
5–6 mmgauntlets, smaller armour plates
10 mmchest and back plates, helmets
high-density 10–12 mmparts that need to hold an edge

Working EVA foam for prop making: cut, shape, glue, seal

The four core steps.

  1. Cut with a fresh blade. Change snap-off blades often; a dull blade tears foam.
  2. Heat-shape with a heat gun. Warm both sides evenly, bend, hold until cool.
  3. Glue with contact cement. Coat both edges, let it go tacky, then press once.
  4. Seal before painting. Flexible sealers such as Plasti Dip or a brushed sealant stop paint soaking in.

Sources and further reading

Where the facts on this page come from.

External reference · 405th.com

The 405th ↗

Halo costume and prop community.